Mkslasertool Setup — V1.1.2.exe

Ensure you are downloading the .exe from a reputable source, such as the official Makerbase GitHub repository.

For those using the MKS DLC32, this version helps you set up the onboard WiFi. It allows you to input your network credentials and connect the board to your local network for wireless engraving via a web browser or the MKS mobile app. How to Install MKSLaserTool Setup V1.1.2.exe Follow these steps to ensure a clean installation: mkslasertool setup v1.1.2.exe

Check that no other software (like LightBurn or LaserGRBL) is open and using the COM port. Ensure you are downloading the

What do you use for designing (LightBurn, LaserGRBL)? How to Install MKSLaserTool Setup V1

💡 Always back up your current G-code configuration ($$ settings) before flashing new firmware, as a fresh install will often reset your machine's travel limits and acceleration speeds.

Set the Baud Rate (typically 115200 for DLC32 or 250000 for standard DLC).

Android Call Recorder for all VoIP Services

Cube ACR for Android enables you to capture cellular phone calls, record WhatsApp calls and conversations in other VoIP apps and messengers, like LINE, Viber, Skype, WeChat and many more!

Great recording quality

Record incoming and outgoing calls in the best possible quality with Cube Call Recorder. Select from multiple recording options and sources to find the one that suits you best.

Stable and reliable

Frequent updates and improvements ensure that all your calls will be recorded via Cube Call Recorder, no matter what.

Cloud backup

Save your recording to Google Drive or via email

Geotagging

See where calls took place on a map (works only on Android)

Smart clean

Auto-remove old recording to free up space

Privacy

Secure your recordings with a PIN lock/TouchID/FaceID

Shake-to-mark

Marking important parts of a conversation (works only on Android)

Ensure you are downloading the .exe from a reputable source, such as the official Makerbase GitHub repository.

Check that no other software (like LightBurn or LaserGRBL) is open and using the COM port.

What do you use for designing (LightBurn, LaserGRBL)?

💡 Always back up your current G-code configuration ($$ settings) before flashing new firmware, as a fresh install will often reset your machine's travel limits and acceleration speeds.

Set the Baud Rate (typically 115200 for DLC32 or 250000 for standard DLC).