Anydesk Wake On Lan Not Working _verified_ <HOT>

On sender: AnyDesk → Remote Devices → Edit target → Advanced → "Send packet to broadcast address" = ON. Set port = 9.

AnyDesk generally uses UDP port or the specific AnyDesk port for WoL. anydesk wake on lan not working

AnyDesk WOL fails in 95% of cases because: On sender: AnyDesk → Remote Devices → Edit

Better: Put another PC on same subnet, install tcpdump or Wireshark, filter udp port 9 . Send test WOL. You should see packet even if target is off. AnyDesk WOL fails in 95% of cases because:

If the network card and router are configured, but AnyDesk still won't wake the device, you may need to tell AnyDesk where to send the signal.

The most common reason WoL fails is that Windows disables the network adapter to save power.

Test with a basic WOL tool from another LAN PC. If that works, blame AnyDesk. If not, fix BIOS/NIC. Then consider whether you actually need AnyDesk WOL or just a better remote power management strategy.