| Action | Steps | |--------|-------| | | Press & hold the pin‑hole reset for 10 s (LED flashes red). | | Change Wi‑Fi | Reset → Re‑run “Add Device” flow in the app. | | Export 30‑day CSV | Web → Analytics → Date Range → Last 30 days → Export. | | Enable MQTT | Settings → Integrations → MQTT → Fill broker → Save . | | Run Firmware Update | Settings → Firmware → Check for Updates → Install . | | Backup Config | Web → System → Backup → Create Backup → Download. |
| 1. Re‑plug power. 2. Reset Wi‑Fi: press the (pin hole) for 5 s. 3. Re‑run the “Add Device” flow. | | App can’t find the hub | Wi‑Fi isolation (guest network) or AP “client isolation” turned on. | Move the hub to the same subnet as your phone, or disable AP isolation. | | Temperature readings drift +2 °C | Sensor offset not calibrated. | Calibrate using a known‑accurate thermometer (Settings → Sensor Calibration). | | Motion sensor triggers false alarms | PIR field obstructed or too sensitive. | Adjust sensitivity in the app (Settings → Motion → Sensitivity) and ensure there’s no reflective surface within 1 m of the sensor. | | Data loss after power failure | Log buffer overflow before backup. | Increase log retention interval (Settings → Storage → Log Interval) or set up cloud sync (Settings → Cloud → Enable). | | Wi‑Fi drops intermittently | Weak signal or channel congestion. | Use a Wi‑Fi analyzer to switch to a less‑crowded 2.4 GHz channel (1, 6, 11). Consider a PoE power source and place the hub near the router. | stasyq 605
Do this, and the 605 will generate a rhythm that is humanly impossible to play—a glitchy, lurching, breathing groove that sounds like a machine trying to learn how to dance. | Action | Steps | |--------|-------| | |
| Action | Recommended Practice | |--------|----------------------| | | In the mobile app, the Health tab shows battery (if using a UPS), signal strength (RSSI), and sensor error codes. Look for green checkmarks . | | Data export | Export a CSV of the last 7 days via the web UI → Analytics → Export . Good for building trend charts in Excel or PowerBI. | | Firmware updates | Auto‑OTA is on by default, but you can manually trigger an update: Settings → Firmware → Check for Updates . | | Power‑outage handling | The unit has a 30 mAh internal capacitor that keeps it alive for ~30 s during a brief outage, preserving the log buffer. After power returns, it will auto‑reconnect and resume logging. | | Physical cleaning | Dust the vent openings (four 12 mm slits) with a soft brush every 2‑3 months. Do not spray liquids directly on the unit. | | | Enable MQTT | Settings → Integrations